Paint designed to cover and seal cracks
Pintyplus Tech Sealer Spray is a paint designed to cover cracks, cervices or fissures caused by the passage of time, especially in outdoor structures and surfaces where it’s necessary to prevent the passage of water. It’s a rubber-based paint that will act as a sealant for these cracks. Its application is simple, several coats should be applied until a thick layer is created, and it can be repainted once the paint is dry.
Colors
SG101 White
SG104 Black
SG113 Gray
Main qualities
- Size 650/500ml
- Coverage = 3m²
- Drying time for small cracks: 2h
- Drying time for large cracks: 5h
- Repaint after 72h
- Heat resistance 100ºC
- Mate finish
How to use Pintyplus Tech Sealer Spray
The surface to be painted must be clean, dry, and free of any contaminants. Remove rust and flakes, if any, with a wire brush. Remove grease stains with solvent.
Shake the aerosol vigorously for 1 minute after the mixing balls rattle. Spray from a distance of 25/30 cm, applying thin, quick coats, first horizontally and then vertically. It is recommended to apply two thin coats rather than one thick coat to achieve uniform coverage and prevent dripping. Once finished, invert the can and press until only gas comes out to clean the nozzle.
- Apply multiple coats until the desired thickness is achieved depending on the application.
- If the crack or fissure is small, less product will be needed; if larger, more will be required.
- Wait a reasonable 5 minutes between coats.
- Apply coats until the crack is sealed; if the product drips due to accumulation, this will not affect the sealing.
- Wait for the paint to dry before repainting.